2004 Kawasaki KX125

This 2004 KX 125 is a fully Restored Pro Circuit Replica. $11000 OBO This was a fun bike to build and has taken a lot of patience and time. I wanted to do it right and not miss. This bike certainly belongs to a collector and or avid motocross enthusiast. It has 2 test rides on it and was recently featured on Whiskey Throttle Media Spotlight and test rode by David Pingree. check it out here. https://www.youtube.com/watch?v=pYpwZ4fydRQ Engine has been completely gone through top to bottom. Once the bottom end checked out, I sent the cylinder to Millennium Technologies to have them re nikasil/ port and polish just so it was crisp. We then paired it with a Wisco piston and kept the stock bore for reliability. I also fabricated and welded mounting brackets to the frame for a custom water pump guard that was in line with what PC did at the time. Some of the work that has been done is listed below. -Custom Phathead racing head. black -Billitron 38 lectron carb w Custom OEM cable -Polished PC pipe and Bills Carbon silencer with stinger end cap (Crispy) -Cerakoted engine cases/water pump and power valve covers -Cerakoted Break hangers/master cylinders/calipers -Master cylinder sight glass weld delete -Master cylinder and calipers fully rebuilt -Red banjo bolts/ Red caps -Haan hubs/ Excel wheel set by Dubya -Light Speed carbon ignition cover, rotor cover F&R, case saver, caliper cover, skid plate, chain guide. -Suspension internals done by Fenix Suspension-Chris Blose -Anodized PC brown forks -Anodized PC brown and hand polished shock body with blue spring. 175 LBS -Renthal 90s retro purple Twin Wall bars W soft grips -Arc levers W new cable -Authentic PC triple clamps reconditioned and anodized PC brown. -Custom PC logo graphics for triple clamps -Custom AMA inspection Tech stickers -Custom graphics kit with gold foil with metallic sparkle laminate. -Black Polysport plastic kit with flow green number plate and F fender -Gold heat shield under tank -PC external coolant reservoir -PC fuel tank vent tube -PC red rear break clevis -TI stem nut and new bearings. -Factory replica wheel block and TI nut -Hinson clutch cover -Hydro blasted linkage with new bearings -Coated Metallic silver frame and sub frame -New OEM kick starter -Factory replica PC seat cover -All new nuts and bolts in combination with some TI bolts in the right places. I can also assist with shipping in an OEM crate to destination for an extra cost as I own a shipping company. Thanks for looking!