Just setup your whip at home and adjust it to fit and your done. Show up to the dunes, clip the whip on and ride. Ready to head home pop it off and store it in the corner till next time.

• Easy on, easy off installation no tools required

• Harder than ever to break a whip because of its flexability (Big money saver)

• More ergonomic, its out of the way when you get on and off the bike

• Better placement for better visibility

Instructions

1) cut your whip down 12 - 18” do not use full length whip

2) round off edges of cut down whip so it can be easily inserted into mount

3) push whip 1” past the bottom of mount and crush the end with plyers or hammer (or rock.. or wrench..)

4) pull the whip up till it sits nicely inside the cut out on the bottom. It should fit very tight since the crushed end has expanded the fiberglass whip

5) ride it like you stole it... (read below..)

Troubleshooting.

1) if the whip pulls back through mount to easily crush the end harder to expand it enough to prevent this

2) if the mount will not stay on fender thoroughly clean your fender especially if you use chemicals to prevent mud from sticking to your fender.

3) if mount still does not stay tighten the setup by doing the following. Push bungee through fender clasp till plastic insert is exposed. Take the plastic insert out and move it in one hole, pull the bungee back through the fender clasp till the plastic insert is again flush with the clasp.

***Its recommended to setup your whip mount to ride 6 - 8 inches from the end of your fender. Find a good balance of far enough back that you won’t kick it when throwing your leg over and far enough forward that its bullet proof.

If you are able to break your whip... we hope you’re ok...