• 100% Cotton Infused Polyester
• Rubberized Vinyl
• Abrasion Resistant Topcoat

SCRUB Designz is one of the largest dirt bike graphics / design companies on the planet.

The company was founded at the end of 2014 by Australian, Mark Roberts. Everything started as a small operation around small group of passionate people. With our progressive designs and high service standards, we quickly became popular in the dirt bike industry.

The SCRUB crew consists of professionals in each department. But not everyone who works at SCRUB DESIGNZ is a motocross rider. This gave us the opportunity to bring new trends, unique looks, new ideas for processes in the production of our products.

1. Remover old seat cover. Staples, flick them out with a flat blade screw driver, then complete with long-nose pliers.


2. Ensure your seat cover is at a suitable temperature, as if it's too cold, it will not stretch so well. Ideal is 70°F- 90°F (21°C - 32°C).  If your work area is below this, either move to a warmer area for fitting, or use a hair dryer or heat gun to warm up the cover.


3. Fitting, start with the front section, or nose.  Position it dead center and pop in a few staples to hold it in place.  6mm staples are best, from an air powered gun, or electric high powered.


4. Once the front has 2-3 staples, and you're happy with the centering, pull over the back edge, get it tight and centered... pop in a few staples again.  Check it's straight. Then check again.


5. Next you can pull one side over the knee area, put in a few staples. Pull it fairly tight. Next, do the other side. Tighter. Few staples there, then, check alignment once again. If you're 'off track', simple to remove a few staples and reposition.


6. Then you can carefully pull and staple your way to the back of the seat on each side. Check alignment as you go!


7. It can be good to involve a second person for this, can help to obtain a better end result. As you go, of course, looking for alignment and any ripples that form.  If they do, remove staples in the area, and pull harder.


8. Stick it back on the bike and you're done! Enjoy!

• Plastics kits
• Seat covers
• Mid forks
• Rim tapes
• Spoke coats
• Grip tapes

All seat covers are made specifically according to the order. The production of seat cover takes a maximum of 48 hours and shipped via Courier afterwards. Tracking number is provided by sms and email.

Please give us a feedback, after you receive your order. We appreciate every feedback either good or bad. We will do everything to make every customer happy with the purchase on SCRUB Designz MX Locker store.

All international parcels are subject to import duties and customs charges. This is not included in the total price. These charges are the buyer's responsibility.

Return shipping paid by: Buyer
Item must be returned within: 30 Days
All returns are subject to a 20% restocking fee.