Nickel YZ/YZF/WR Nickel Wurks Bolt Kit Yamaha 2 & 4 stroke competition cycles

All New YAMAHA YZ/YZF Nickel Wurks Dress-Up Bolt kit! This HIGH QUALITY Nickel Wurks bolt kit is for all 1990 & up YZ and YZF competition motorcycles. 2-Stroke: YZ 65 80 85 125 125X 250 250X 250WR 4-Stroke: YZ250F YZ250FX YZ400F YZ426F YZ450F YZ450FX WR250F WR450F This kit uses 10.9 grade nickel plated fasteners. They are all designed with performance in mind. Configured to bring your YAMAHA YZ YZF or WR to WURKS status using only the best fasteners. Full set of modern Fork Guard bolts, 6 Nickel wide head radiator shroud bolts, Nickel seat bolts, 2 correct square nuts for rear fender, a full Nickel Sprocket bolt kit... plastics fender body bolts and fender washers, most visible engine side cover bolts, radiator bolts, shifter bolt, Flange Nuts for cylinder and head, exhaust bolts, most triple clamp and handlebar clamp bolts, front axle pinch bolts, front brake caliper bolts, fuel tank bolts, clutch and front brake perch bolts, and number plate and side panel bolts...all with a hard and beautiful nickel finish. We give you an assortment of trick Yamaha blue anodized drilled washers. You also get a huge assortment of M5, M6, and M8 Nickel Wurks bolts. Nearly enough to replace all your bike's engine covers, triple clamps, bar clamps, front brake caliper, front axle pinch bolts, body plastics, radiator bolts, chain slider, swingarm components. Additional bolts may be needed depending on your make and model. These are all available as refills in our specbolt website store for around a buck a bolt. M6 Nickel Wurks flange bolts in this kit range in size from M6x10 up to M6x45 and look beautiful used on your engine covers and plastics. M8 Nickel Wurks flange bolts in this kit range in size from M8x12 up to M8x45 and are perfect to replace your old bolts on your seat, front end, triple-clamps, bar mounts, axle pinch bolts, brake caliper mounts etc... M6 Nickel Wurks wide head flange bolts in this kit in 2 sizes. M6x12 & M6x16 and are great for mounting radiator shrouds and bodywork plastics. Our OEM exact match Specbolt Collar washers and bushings are perfect size and for mounting plastics and bodywork. These allow body bolts to be fully tightened and greatly reduce the chance of splitting your plastic while tightening. We give you 2 each of the 3 sizes of hard to find oval CNC bushings only available previously from Yamaha. This kit contains a full assortment of Nickel Plated Flange nuts in M6, M8, and M10 sizes. An assortment of the most needed Fender and Flat Washers are included. A Full set of Yamaha Sprocket Bolts with thread lock pre-applied and matching flat washers and class 10 flange bolts. A full set of 6 Yamaha specific Fork Guard Bolts are included in the set. A big improvement over stock. They have been re-engineered to hold the fork guards a little firmer in place and eliminate any wiggle found on some models. This is especially helpful when running a holeshot device.