Specbolt Honda CR/CRF Nickel Wurks Bolt Kit for 2 & 4 stroke competition cycles

All New Honda CRF Nickel Wurks Dress-Up Bolt kit! This HIGH QUALITY Nickel Wurks bolt kit is for all... HONDA CR and CRF bikes from 1990 and up. 2 Strokes: CR65 CR80 CR85 CR125 CR250 CR500 4 Strokes: CRF150R CRF250R CRF450R This kit uses 10.9 grade nickel plated fasteners. They are all designed with performance in mind. Configured to bring your HONDA CR or CRF to WURKS status using only the best fasteners. 6 Nickel Fork Guard bolts, 6 Nickel M5 shouldered radiator shroud bolts, 3 Sets of Nickel seat bolts, 2 correct square nuts for rear fender, a full Nickel Sprocket bolt kit... plastics fender body bolts and fender washers, engine side cover bolts, radiator bolts, shifter bolt, Flange Nuts for cylinder and head, exhaust bolts, most triple clamp and handlebar clamp bolts, front axle pinch bolts, front brake caliper bolts, fuel tank bolts, clutch and front brake perch bolts, and number plate and side panel bolts...all with a hard and beautiful nickel finish. We give you an assortment of trick Red drilled washers. You also get a huge assortment of M5, M6, and M8 Nickel Wurks bolts. Nearly enough to replace all your bike's engine covers, triple clamps, bar clamps, front brake caliper, front axle pinch bolts, body plastics, radiator bolts, chain slider, swingarm components. For a full restoration, additional bolts may be needed depending on your make and model. These are all available as refills in our store for around a buck a bolt. M6 Nickel Wurks flange bolts in this kit range in size from M6x10 up to M6x45 and look beautiful used on your engine covers and plastics.M8 Nickel Wurks flange bolts in this kit range in size from M8x12 up to M8x45 and are perfect to replace your old bolts on your seat, front end, triple-clamps, bar mounts, axle pinch bolts, brake caliper mounts etc... M6 Nickel Wurks wide head flange bolts in this kit in 2 sizes. M6x12 & M6x16 are great for mounting radiator shrouds and bodywork plastics. Our Specbolt Collar washers are perfect size and for mounting plastics and bodywork. These allow body bolts to be fully tightened and greatly reduce the chance of splitting your plastic while tightening. This kit contains a full assortment of Nickel Plated Flange nuts in M6, M8, and M10 sizes. An assortment of the most needed Fender and Flat Washers are included. A Full set of OEM Matching Honda Torx Sprocket Bolts with thread lock pre-applied. Complete with matching flat washers and class 10 flange bolts. A full set of 6 Honda specific Fork Guard Bolts are included in the set. A big improvement over stock. They have been re-engineered to hold the fork guards a little firmer in place and eliminate any wiggle found on some models. This is especially helpful when running a holeshot device. Additional fasteners available anytime direct from Specbolt's website if you run low.