Used Custom Cycle Engineering 49mm 2" Under Stock Front Fork Tubes Set. Precision-machined in the USA by Custom Cycle Engineering, these premium hard-chrome fork tubes are specifically engineered to provide an aggressive, slammed look by dropping the front end height on modern right-side-up mid-glide and narrow-glide front ends without sacrificing internal fluid damping tracking.

The structural component tubes have been fully cleaned, degreased, and bench-inspected for physical wear. Both tube columns are verified straight with zero bowing, flat spots, or rotational warping along the tracking walls. As checked in the shop photos, the outer tube diameter measures 49mm with an overall top-to-bottom length specification of 23-5/8 inches (23.625"). For custom builders, this exact size is marketed as a 2" under-stock lowering tube configuration for modern cruiser models. One tube features a clean hand-lettered "L" marker designation on the upper rim to identify original orientation mapping.

The interior bores are clean, housing the factory internal green plastic slotted guide sleeves and lower oil-seal landing grooves fully intact and ready to receive your lowering springs and damper assemblies.

Important Condition Note: This pair is a used inventory lot in solid mechanical shape. The exterior surfaces display typical aesthetic handling marks, light superficial storage rub scratches, and minor finish dulling along the high-visibility outer walls. There are no deep structural gouges, pitting spots, or stone dings that would slice high-pressure oil seals or restrict smooth travel travel compression, establishing an excellent, cost-effective replacement set for a bike lowering project.

COMPATIBILITY / FITMENT