Engine motor cylinder jug barrel 11200-26810 removed from a 1988 Suzuki RM250.
Very nice used condition and appears to have very low hours, possibly only 5-10 hours. The bore is very fresh with a good cross-hatch pattern and measures approximately 67.25mm. The cylinder is on its first oversize bore and includes the matching first-over Wiseco piston that was being run with it. Recently bored and super clean.
⚠️ Power Valve Note: One of the two original power valve shaft bushings has been replaced with a same-size dowel. It should still function, but it is not the original bushing setup. This can be seen in the photos.
This is a vintage 1988 RM250 cylinder that is becoming harder to find, especially in this fresh condition.
Please review photos closely to confirm the condition, bore, power valve modification, fitment, and everything included. What you see is exactly what you will receive.
⚠️ Hardware Disclaimer: Any hardware (bolts, clips, fasteners, etc.) shown in photos is not guaranteed to be included and should be considered a free extra if received.
